Suzuki LT-Z250 - Engine Top Side

3-70 ENGINE
 Apply SUZUKI BOND to the mating surface of the secondary
bevel gear cover.
, 99104-31140: SUZUKI BOND  1207B (USA)
- 99000-31110: SUZUKI BOND  1215 (Others)
 Install the secondary bevel gear cover.
NEUTRAL SWITCH
 Install the springs and switch contacts.
 Fit new O-ring and install the neutral switch
1.
 Tighten the neutral switch bolts to the specified torque.
" Neutral switch bolt: 7 N•m (0.7 kgf-m, 5.0 lb-ft)
ENGINE TOP SIDE
PISTON
 Install the piston rings in the order of oil ring, 2nd ring and 1st
ring.
 The first member to go into the oil ring groove is a spacer
1.
After placing the spacer, fit the two side rails
2.
NOTE:
Side designations, top and bottom, are not applied to the spacer
and side rails: Those can be positioned each either way.
'
When installing the spacer, be careful not to allow its
two ends to overlap in the groove.
INCORRECT
CORRECT
PartShark.com
877-999-5686