ENGINE 3-9
Check that the gearshift lever plays
A, up and down, are
same. If not, set the clutch release outer guide in suitable
position.
Fix the clutch release outer guide by tightening the clutch
release outer guide nuts
1.
Loosen the locknut
2.
Tighten the adjusting screw
3 until it stops.
Loosen the adjusting screw
3 1/16 1 /8 turn.
Tighten the locknut
2 to the specified torque while holding
the adjusting screw
3.
" Locknut
2: 23 N•m (2.3 kgf-m, 16.5 lb-ft)
Apply engine oil to the O-ring and cap thread lightly.
Tighten the clutch adjuster cap to the specified torque.
" Clutch adjuster cap: 15 N•m (1.5 kgf-m, 11.0 lb-ft)
Engage the secondary driven gear shaft to the universal joint.
Install new gasket as its projections face outside.
Gearshift lever
PartShark.com
877-999-5686
To Next Page
Loading...
