8-28 ELECTRICAL SYSTEM
Make sure that air bubbles
6 are coming up into each elec-
trolyte container, and leave it in this position for more than 20
minutes.
NOTE:
If no air bubbles are coming up from a filler port, tap the bottom
of the electrolyte container two or three times.
Never remove the container from the battery.
After confirming that the electrolyte has entered the battery
completely, remove the electrolyte container from the battery.
Wait for more than 20 minutes.
Insert the caps
3 into the filler holes, pressing in firmly so that
the caps do not protrude above the upper surface of the bat-
tery top cover.
"
For initial charging, use a charger specially designed for MF
batteries.
* Never use anything except the specified battery.
* Once install the caps to the battery; do not remove
the caps.
* Do not tap the caps with a hammer when installing
them.
CORRECT INCORRECT
PartShark.com
877-999-5686
To Next Page
Loading...
