Suzuki LT-Z250 - Page 199

CHASSIS 7-37
 Remove the tie rod ends with a commercially available ball
bearing joint remover.
 Remove the cotter pin and steering shaft nut
9, washer 0
and dust seal
A.
$
 Remove the O-ring
B.
 Remove the steering shaft holder bolts.
 Remove the steering shaft holder half.
 Remove the steering shaft
C.
 Remove the dust seals
D from the steering shaft.
 Remove the steering shaft holder half
E.
Replace the removed cotter pins with new ones.
PartShark.com
877-999-5686