SERVICE DATA
CARBRETOR
FUEL + OIL
ITEM
SPECIFICATION
* E-19 * E-28, 33
Carburetor type MIKUNI BSR29 ←
Bore size 29 mm
(1.14 in)
←
I.D. No. 21G0 21G1
Idle r/min 1 500 ± 100 r/min ←
Float height 13.0 ± 1.0 mm
(0.51 ± 0.04 in)
←
Main jet (M.J.) #125 #
Jet needle (J.N.) 5DH54-2nd ←
Needle jet (N.J.) P-0M #
Pilot jet (P.J.) #20 #
Pilot screw
(P.S.) 1 and 1/2 turns back PRE-SET
Throttle cable play 3 – 5 mm
(0.12 – 0.20 in)
←
Starter (enricher) plunger cable
play
0.5 – 1.0 mm
(0.02 – 0.04 in)
←
ITEM SPECIFICATION NOTE
Fuel type Use only unleaded gasoline of at least 87 pump
octane (R/2 + M/2) or 91 octane or higher rated
by the Research Method.
Gasoline containing MTBE (MethyI Tertiary
ButyI Ether), less than 10% ethanol, or less than
5% methanol with appropriate cosolvents and
corrosion inhibitor is permissible.
E-28, 33
Gasoline used should be graded 91 octane or
higher. An unleaded gasoline is recommended.
E-19
Fuel tank capacity including
reserve
* 9.7 L
(2.6/2.1 US/lmp gal)
Reserve
* 2.1 L
(0.6/0.5 US/lmp gal)
Engine oil type SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Engine oil capacity
Change
2 200 ml
(2.3/1.9 US/lmp qt)
Filter change
2 300 ml
(2.4/2.0 US/lmp qt)
Overhaul
2 500 ml
(2.6/2.2 US/lmp qt)
Final gear oil type Hypoid gear oil SAE #90, API grade GL-5
Final gear oil capacity 190 ml
(6.4/6.7 US/lmp oz)
LT-Z250K9 (09 MODEL) 14-3
PartShark.com
877-999-5686
To Next Page
Loading...
