Suzuki LT-Z250 - Page 56

3-14 ENGINE
 Remove the C-ring
5.
'
CYLINDER HEAD
 Remove the cylinder head nuts (M6)
1.
 Loosen the cylinder base nuts (M6)
2.
 Remove the cylinder head nuts (M8) diagonally.
 Remove the cylinder head.
NOTE:
If the cylinder head does not come off, lightly tap on the finless
portion of it with a plastic hammer.
CYLINDER
 Remove the dowel pins, cylinder head gasket and cam chain
guide
1.
 Remove the cylinder base nuts (M6).
 Remove the cylinder.
NOTE:
* Be careful not to drop the dowel pins into the crankcase.
* If the cylinder does not come off, lightly tap on the finless por-
tion of it with a plastic hammer.
PISTON
 Remove the piston pin circlip
1.
 Remove the piston pin and piston.
NOTE:
Place a rag under the piston so as not to drop the piston pin cir-
clip into the crankcase.
 Remove the cylinder gasket and dowel pins.
Do not drop the C-ring
5 into the crankcase.
PartShark.com
877-999-5686