5-32 CHASSIS
BRAKE SHOE
Inspect the brake shoes for wear or damage. If any wear or
defects are found, replace the brake shoes as a set.
REAR AXLE
Support the rear axle with the V-blocks and measure the rear
axle runout with the dial gauge as shown. If the runout exceeds
the service limit, replace the rear axle with a new one.
09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
Rear axle runout:
Service Limit: 3 mm (0.12 in)
STOPPER RING
Inspect the stopper ring for wear or damage. If any wear or
defects are found, replace it with a new one.
REAR SPROCKET
Inspect the sprocket teeth for wear. If they are worn as illus-
trated, replace the sprocket and drive chain.
A: Normal wear
B: Excessive wear
• Unlock the rear sprocket washer 1.
• Remove the bolts and rear sprocket 2.
• Remove the rear sprocket washer 1.
Replace the brake shoes as a set. Otherwise braking
performance will be adversely affected.
The removed stopper ring must be replace with a new
one.
The removed rear sprocket washer must be replaced
with new ones.
PartShark.com
877-999-5686
To Next Page
Loading...
