2-20 PERIODIC MAINTENANCE
CHASSIS NUTS AND BOLTS
Check that all chassis nuts and bolts are tightened to their specified torque. (Refer to page 2-21 for the loca-
tions of the following nuts and bolts.)
Tighten initially at 1 month and every 3 months there-
after.
Item N·m kgf-m lb-ft
1 Front suspension arm bolt 50 5.0 36.0
2 Knuckle arm nut 50 5.0 36.0
3 Tie-rod end nut 29 2.9 21.0
4 Tie-rod locknut 29 2.9 21.0
5 Steering shaft lower nut 29 2.9 21.0
6 Steering shaft holder bolt 23 2.3 16.5
7 Handlebar clamp bolt 26 2.6 19.0
8 Front shock absorber bolt
(upper) 29 2.9 21.0
(lower) 29 2.9 21.0
9 Front hub nut 65 6.5 47.0
0 Wheel set nut (front and rear) 28 2.8 20.0
A Front brake cable equalizer bolt 6.5 0.65 4.5
B Front brake cam lever nut 3.3 0.33 2.5
C Swingarm pivot nut 102 10.2 74.0
D Rear shock absorber bolt 29 2.9 21.0
E Rear shock absorber nut 29 2.9 21.0
F Rear hub nut 75 7.5 54.0
G Rear brake cam lever nut 7.7 0.77 5.5
H Rear brake panel nut 28 2.8 20.0
I Rear axle housing bolt 50 5.0 36.0
J Rear sprocket bolt 23 2.3 16.5
K Footrest bolt 26 2.6 19.0
PartShark.com
877-999-5686
To Next Page
Loading...
