PERIODIC MAINTENANCE 2-19
STEERING
Steering system should be adjusted properly for smooth manip-
ulation of the handlebar and safe running.
TOE-IN
• Place the vehicle on level ground.
• Make sure the tire pressure for both tire is the same and set to
the proper specification.
• Set the front wheels in the straight position.
• Place a load of 30 kg (66 lbs) on the seat.
• Measure the distance A and B of the front wheels, with a
toe-in gauge as shown and calculate the difference between
A and B.
Toe-in:
Standard: 1.5 ± 3 mm (0.06 ± 0.12 in)
• If the toe-in is out of specification, bring it into the specified
range. (5-28)
SUSPENSIONS
• Support the vehicle with a jack and wooden blocks.
• Remove the front and rear wheels. (5-8)
• Inspect the suspension arm, swingarm and bushing for
scratches, wear, or defect. If any defects are found, replace
them with new ones. (5-19 and 5-40)
• Inspect the front and rear shock absorbers for oil leakage or
defects. If any defects are found, replace them with new ones.
(5-19 and 5-40)
Inspect initially at 1 month and every 3 months there-
after.
Forward
Inspect every 6 months.
PartShark.com
877-999-5686
To Next Page
Loading...
