Suzuki LT-Z50 - Inspection; Reassembly and Remounting

5-40 CHASSIS
INSPECTION
REAR SHOCK ABSORBER
Inspect the shock absorber body and bushing for damage and
oil leakage. If any defects are found, replace it with a new one.

SWINGARM PIVOT SHAFT
Check the pivot shaft for runout with a dial gauge and replace it
if the runout exceeds the limit.
 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
 Swingarm pivot shaft rumout:
Service Limit: 0.6 mm (0.02 in)
SWINGARM
Inspect the swingarm for distortion or damage. If any defects are
found, replace it with a new one.
BUSHING
Inspect the bushing for wear or damage. If any defects are
found, replace it with a new one.
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear suspension in the reverse
order of removal and disassembly. Pay attention to the following
points:
Do not attempt to disassemble the rear shock
absorber. It is unserviceable.
PartShark.com
877-999-5686