Suzuki LT-Z50 - Engine Oil

PERIODIC MAINTENANCE 2-9
ENGINE OIL
ENGINE OIL LEVEL CHECK
Follow the procedure below to inspect the engine oil level.
• Place the vehicle on level ground.
• Remove the maintenance lid. (5-6)
• Start the engine and run it for a few minutes.
• Stop the engine and wait three minutes.
• Check the engine oil level with the engine oil dipstick 1.

• Install the filler cap 2 securely.
ENGINE OIL REPLACEMENT
The oil should be changed while the engine is warm.
• Place the vehicle on level ground.
• Remove the maintenance lid. (5-6)
• Place an oil pan under the engine oil drain plug 1, and then
drain out the engine oil by removing the engine oil drain plug
1 and engine oil filler cap 2.
• Tighten the engine oil drain plug 1, with the new washer, to
the specified torque, and then pour the new oil through the oil
filler hole. When performing an oil change, the engine will hold
about 300 ml (0.6/0.5 US/lmp qt) of oil. Use API SF/SG or SH/
SJ with JASO MA.
 Engine oil drain plug: 12 N·m (1.2 kgf-m, 8.5 lb-ft)
• Check the engine oil level above.
 Engine oil capacity:
Oil change: 300 ml (0.6/0.5 US/lmp qt)
Overhaul: 350 ml (0.7/0.6 US/lmp qt)
Inspect each time the vehicle is ridden.
Replace initially 1 month and every 6 months thereaf-
ter.
* Check the engine oil level with the dipstick 1 before
each time the vehicle is ridden.
* Be sure the engine oil level is always between the
“L” (low) line and the “F” (full) line.
“L” “F”
PartShark.com
877-999-5686