Suzuki LT-Z50 - Starter Pinion

3-34 ENGINE
• Remove the oil seal 1 with the special tool.
 09913-70210: Bearing installer set

• Install the oil seal 2 with the special tool.
 09913-70210: Bearing installer set
• Apply SUZUKI SUPER GREASE “A” to the oil seal lip.

99000-25010: SUZUKI SUPER GREASE “A” or equivalent
STARTER PINION
INSPECTION
• Check that the gear 1 rotates in the direction A when hold-
ing the gear 2.
• Check that the gear 1 rotates in the direction B and C when
holding the gear 2.
• If anything unusual is found, replace the starter pinion with a
new one.
The removed oil seal must be replaced with a new one.
PartShark.com
877-999-5686