2-18 PERIODIC MAINTENANCE
TIRES
TIRE TREAD CONDITION
Operating the vehicle with excessively worn tires will decrease
riding stability and consequently invite a dangerous situation. It
is highly recommended to replace a tire when the remaining
depth of the tire tread reaches the following specification.
09900-20805: Tire depth gauge
Service Limit:
Tire tread depth: Front 4.0 mm (0.16 in)
Rear 4.0 mm (0.16 in)
TIRE PRESSURE
If the tire pressure is too high or too low, steering will be
adversely affected and tire wear will increase. Therefore, main-
tain the correct tire pressure for good roadability and a longer
tire life. Cold inflation tire pressure is as follows.
Cold inflation tire pressure:
Front: 20 kPa (0.20 kgf/cm², 2.9 psi)
Rear : 20 kPa (0.20 kgf/cm², 2.9 psi)
VEHICLE LOAD CAPACITY LIMIT: 38 kg (84 lbs)
Inspect every month.
4.0 mm
To minimize the possiblility of tire damage from
over-inflation, we strongly recommended that a man-
ual type air pump be used rather than a high pressure
air compressor as found in service stations. When fill-
ing air into the tires, never exceed 70 kPa (0.7 kgf/cm²,
10 psi).
The standard tire fitted on this vehicle is an
AT16×8-7✩ for the front and rear. The use of tires
other than those specified may cause instability. It is
highly recommended to use the specified tires.
PartShark.com
877-999-5686
To Next Page
Loading...
