Suzuki LT-Z50 - Final Reduction Gear Box and Cvt Case

3-28 ENGINE
FINAL REDUCTION GEAR BOX AND CVT
CASE
DISASSEMBLY
• Remove the snap ring 1 and engine sprocket 2.
• Remove the drain plug 3 and gasket.
• Drain final reduction gear box oil.
• Remove the final reduction gear box cover 4.
NOTE:
Loosen the final reduction gear box cover bolts little by little and
diagonally.
• Remove the dowel pins 5.
• Remove the washer 6 and 7.
• Remove the drive shaft 8.
• Remove the counter shaft 9 with the special tool.
 09920-13120: Crankshaft separator
COUNTER SHAFT INSPECTION
Inspect the counter shaft wear or damage.
If it is worn or damaged, replace it with a new one.
PartShark.com
877-999-5686