ENGINE 3-29
DRIVE SHAFT INSPECTION
Inspect the drive shaft for wear or damage.
If it is worn or damaged, replace it with a new one.
BEARING INSPECTION
Rotate the bearing inner race by finger to inspect for abnormal
play, noise and smooth rotation while the bearings are in the
those cases.
Replace the bearing in the following procedure if there is any-
thing unusual.
• Remove the oil seal 1 with the special tool.
09913-50121: Oil seal remover
• Remove the oil seal 2 with the special tool.
09913-50121: Oil seal remover
• Remove the bearings with the special tool.
09913-70210: Bearing installer set
09921-20240: Bearing remover set
Play
Play
The removed oil seal must be replaced with a new one.
The removed oil seal must be replaced with a new one.
The removed bearings should be replaced with new
ones.
PartShark.com
877-999-5686
To Next Page
Loading...
