CHASSIS 5-23
REASSEMBLY AND REMOUNTING
Reassemble and remount the steering in the reverse order of
removal and disassembly. Pay attention to the following points:
• Install the steering shaft bushing with the special tool.
09924-84521: Bearing installer set
STEERING SHAFT
• Apply grease to the steering shaft lower dust seal 1, steering
shaft holders 2, dust seals 3, O-ring 4 and steering shaft 5
before remounting the steering shaft 5.
99000-25161: WATER RESISTANCE GREASE or equiv-
alent
• Install the steering shaft lower dust seal 1, steering shaft
holders 2, dust seals 3 and O-ring 4 to the steering shaft
5.
• Tighten the steering shaft lower nut to the specified torque
and install the new cotter pin.
Steering shaft lower nut: 29 N·m (2.9 kgf·m, 21.0 Ib-ft)
To prevent the entry of dirt, the dust seal end A must
face forward when installed on the steering shaft 5.
PartShark.com
877-999-5686
To Next Page
Loading...
