5-24 CHASSIS
• Tighten the steering shaft holder bolts to the specified torque
and install the new cotter pins.
Steering shaft holder bolt: 23 N·m (2.3 kgf·m, 16.5 Ib-ft)
TIE-ROD
• Tighten the tie-rod end nuts to the specified torque.
Tie-rod end nut: 29 N·m (2.9 kgf-m, 21.0 lb-ft)
NOTE:
After installing the tie-rod end nuts, install the new cotter pins
into the tie-rod ends.
• When installing the tie-rod end, make sure the punched mark
“L” on the tie-rod ends come inside.
NOTE:
The locknuts 1 have left-hand threads.
HANDLEBAR
• Set the white mark on the handlebar lower holder to the for-
ward.
• Align the punched mark on the handlebars with matching sur-
face of the handlebar holders.
Forward
PartShark.com
877-999-5686
To Next Page
Loading...
