6-12 ELECTRICAL SYSTEM
Step 3
1) Measure the starter relay voltage at the starter relay connectors (between Y/G + and B/W -) when the
starter button is pushed.
Is a voltage OK?
Step 4
1) Check the starter relay. (6-16 to -17)
Is the starter relay OK?
Engine does not turn though the starter motor runs.
• Faulty starter pinion. (3-34)
STARTER MOTOR REMOVAL
• Disconnect the battery - lead wire.
• Remove the right frame cover. (5-4)
• Remove the starter motor 1.
• Disconnect the starter motor lead wire 2.
YES Go to Step 4.
NO
• Faulty engine stop switch.
• Faulty starter button.
• Faulty parking brake switch.
• Faulty remote engine stop switch.
• Faulty ignition switch.
• Poor contact of connector.
• Open circuit in wiring harness.
YES Poor contact of the starter relay.
NO Faulty starter relay.
PartShark.com
877-999-5686
To Next Page
Loading...
