CHASSIS 5-21
• Remove the steering shaft bushing.
• Remove the dust seals 3 and steering shaft lower dust seal
4.
• Separate the tie-rod ends 5, locknuts (6, 7) and tie-rods 8.
INSPECTION
Inspect the removed parts for the following abnormalities.
* Handlebar distortion.
* Handlebar clamp wear.
DUST SEALS AND O-RING
Inspect the dust seals and O-ring for wear or damage.
If any defects are found, replace them with new ones.
KNUCKLE ARM BUSHING
Insert the spacer into the bushing and inspect for abnormal
noise and smooth rotation while rotating the spacer.
If any defects are found, replace it with a new one.
The removed steering shaft bushing must be replaced
with a new one.
The locknuts 6 have left-hand threads.
PartShark.com
877-999-5686
To Next Page
Loading...
