CHASSIS 5-25
• Install the handlebar upper holders as shown.
• First, tighten the bolts 1 to the specified torque and then
tighten the bolts 2 to the specified torque.
Handlebar clamp bolt: 26 N·m (2.6 kgf-m, 19.0 lb-ft)
• Make sure the cable, harness are routing properly.
HANDLEBAR SWITCH
• Align the handlebar switch lug 1 with the handlebar hole 2.
THROTTLE LEVER CASE
• Align the throttle lever case lug 1 with the handlebar hole 2.
FRONT SUSPENSION
• Install the knuckle arm bushing with the special tool.
09924-84510: Bearing installer set
• Apply grease to the knuckle arm bushings, dust seals and
spacer.
• Install the spacer and the dust seals.
99000-25161: WATER RESISTANCE GREASE or equiv-
alent
Forward
PartShark.com
877-999-5686
To Next Page
Loading...
