CHASSIS 5-41
• Install the swingarm pivot bushings with the special tool.
09941-34513: Steering race installer
NOTE:
When installing the swingarm bushings 1 to the swingarm 2,
and confirm the distance between the end of the swingarm 2
and bushing edge A is 1.5 mm (0.059 in).
• Tighten the swingarm pivot nut to the specified torque.
Swingarm pivot nut: 102 N·m (10.2 kgf·m, 74.0 Ib-ft)
• Tighten the rear shock absorber bolt to the specified torque.
Rear shock absorber bolt: 29 N·m (2.9 kgf·m, 21.0 Ib-ft)
• Tighten the rear shock absorber nut to the specified torque.
Rear shock absorber nut: 29 N·m (2.9 kgf·m, 21.0 Ib-ft)
1.5 mm (0.059 in)
PartShark.com
877-999-5686
To Next Page
Loading...
