ELECTRICAL SYSTEM 6-9
REGULATED VOLTAGE
• Remove the seat. (5-4)
• Start the engine and keep it running at 2 800 r/min.
Measure the DC voltage between the + and - battery termi-
nals with the multi-circuit tester. If the voltage is not within the
standard range, inspect the generator and regulator/rectifier.
(6-9 and 6-10)
NOTE:
When making this test, be sure that the battery is in
fully-charged condition.
09900-25008: Multi-circuit tester set
Tester knob indication: Voltage ()
Regulated voltage (Charging output):
13.5 – 15.2 V at 2 800 r/min.
GENERATOR COIL RESISTANCE
• Remove the left frame cover. (5-4)
• Disconnect the generator coupler 1.
Measure the resistance between the W/R wire and ground with
the multi-circuit tester.
If the resistance is not within the standard range, replace the
generator coil with a new one.
09900-25008: Multi-circuit tester set
Tester knob indication: Resistance (Ω)
Generator coil resistance:
0.5
–
2.0
Ω
(W/R – Ground)
NOTE:
When making above test, it is not necessary to remove the gen-
erator.
V
W/R
PartShark.com
877-999-5686
To Next Page
Loading...
