Suzuki LT-Z50 - Page 48

ENGINE 3-7
• Install the drive chain 1.
• Install the clip 2.

• Apply SUZUKI SUPER GREASE “A” to the O-ring.

99000-25010: SUZUKI SUPER GREASE “A” or equivalent

• Tighten the carburetor mounting bolts 3 to the specified
torque.
 Carburetor mounting bolt: 6 N·m (0.6 kgf-m, 4.5 lb-ft)
• Install the exhaust pipe gasket 4.

The drive chain joint clip should be attached in the
way that the slit end will face opposite the direction of
travel.
Direction of travel
The removed O-ring must be replaced with a new one.
The removed gasket must be replaced with a new one.
PartShark.com
877-999-5686