ENGINE 3-17
• Remove the gearshift cam plate 1.
• Remove the gearshift cam stopper 2.
PRIMARY DRIVE GEAR
Remove the primary drive gear by removing the primary drive
gear bolt with the special tool.
% 09930-40113: Rotor holder
&
This bolt has left-hand thread.
Turning it counter-clockwise may cause damage.
• Remove the cam chain tensioner and the chain.
• Remove the cam chain drive sprocket 1 and the thrust washer
2.
OIL FILTER
• Remove the oil filter with the special tool.
% 09915-40610: Oil filter wrench
DRIVESHAFT BOLT/SECONDARY DRIVEN GEAR SHAFT
NUT
• Install the universal joint on the secondary driven gear shaft.
• While holding the universal joint with an adjustable wrench,
remove the driveshaft bolt 1 and the secondary drive gear
shaft nut 2.
&
The driveshaft bolt 1 has left-hand thread.
Turning it counter-clockwise may cause damage.
To Next Page
Loading...
