Where Month is the name of the month.
Where Day is the day of the month from 0 to 31.
Where HHMMSS is the hour, minute, and seconds in a 24-hour format.
The fields are separated by semi-colons, for example, HH:MM:SS.
Where Year is the calendar year from 1970 through 2037.
11
From the Main_Menu > Settings > Alerts > Email view, use the following
commands to enter the SMTP server name and the email addresses for
appliance failure alerts.
Email SMTP Add Server [Account]
[Password]
The Server variable is the host name of the target SMTP
server that is used to send emails. The [Account] option
identifies the name of the account that was used or the
authentication to the SMTP server. The [Password]
option is the password for authentication to the SMTP
server.
Enter the SMTP server name
Email Software Add Addresses
Where Addresses is the user's email address. To define
multiple emails, separate them with a semi-colon.
Enter email addresses
12
Set the role for the appliance to a master server.
From the Main_Menu > Appliance view, run the following command:
Master
13
To configure storage partitions, you must do the following:
■ Enter a size for the NetBackup Catalog on the master server.
To skip the configuration for the NetBackup Catalog partition, enter 0 when
prompted for its size. To keep the partition at its current size, press Enter.
■ Enter a storage pool size in GB or TB.
To skip the storage pool size configuration for any partition, enter 0 when
prompted for its size. To keep the storage pool at its current size, press
Enter.
■ Enter a disk pool name.
The default names are dp_adv_<hostname> for AdvancedDisk and
dp_disk_<hostname> for Deduplication. To keep the default names, press
Enter.
■ Enter a storage pool name.
140Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
