The default names are stu_adv_<hostname> for AdvancedDisk and
stu_disk_<hostname> for Deduplication. To keep the default names, press
Enter.
The storage prompts appear in the following order:
NetBackup Catalog volume size in GB [default size]:
AdvancedDisk storage pool size in GB/TB [default size]:
AdvancedDisk diskpool name:
AdvancedDisk storage unit name:
MSDP storage pool size in GB/TB [default size]:
MSDP diskpool name:
MSDP storage unit name:
After you configure the storage partitions, a summary of the storage
configuration appears with the following prompt:
Do you want to edit the storage configuration? [yes, no]
Type yes to make any changes, or type no to keep the current configuration.
14
Disconnect the laptop from the NIC1 appliance port.
Note: If your network uses the 192.168.x.x IP address range, refer to the
following topic for important information:
15
If you have a media server that needs reconfiguration, now is the time to
configure the master server to communicate with it, then reconfigure your media
server.
See “Configuring a master server to communicate with an appliance media
server” on page 141.
See “Reconfiguring a 52xx media server appliance from the USB drive using
the NetBackup Appliance Shell Menu” on page 143.
Configuring a master server to communicate with an appliance
media server
Before you configure a reimaged media server appliance, you must ensure that the
master server you plan to use with it is configured. That allows for appropriate
communication to occur between the master server and the reconfigured media
server appliance.
The following procedure describes how to configure a master server to communicate
with an appliance media server.
141Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
