3
Enter the number of the checkpoint that you want to use for the Rollback
operation.
4
Enter Yes, if you want to automatically restart all appliances after the rollback
completes.
5
Enter Yes a second time to confirm that you want to restart the appliance
automatically after the rollback operation completes.
6
Enter Yes to begin the rollback to a checkpoint operation.
The following status is provided once the rollback operation is started.
Rollback to checkpoint? (yes/no) yes
- [Info] Stopping NetBackup Services...please wait.
- [Info] PERFORMING REVERT TO USER CHECKPOINT
- [Info] This takes approx. 15 to 20 mins. Please wait...
- [Info] Rollback to Appliance Checkpoint (User directed
checkpoint) successful.
A reboot of the appliance is required to complete the
checkpoint rollback. Reboot now? (Type REBOOT to continue) REBOOT
Rebooting the appliance now...
- [Info] Rebooting app2.symantec.com
Please reconnect to the appliance shell menu to continue
using this appliance.
The system is going down for reboot NOW!
About appliance rollback validation
This page displays a list of the appliance configuration components that are rolled
back.
Note: During a rollback process, all appliance functions are suspended.
Rolling back to an appliance checkpoint reverts the following components:
■ The appliance operating system
■ The appliance software
■ The NetBackup software
■ The network configuration
157Disaster Recovery
Disaster recovery scenarios
To Next Page
Loading...
