Symantec NetBackup 5220 - Page 176

Table 12-6
Manage > Host
Recommended actionExplanationError messages
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The appliance cannot reset the
current deduplication
parameters to the default
settings.
Error resetting deduplication
parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current deduplication
parameters for the appliance
cannot be displayed.
Error while retrieving deduplication
parameters
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current deduplication
parameters for the appliance
cannot be updated to the new
parameters.
Error in updating deduplication
Parameters
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The appliance cannot reset the
current data buffer parameters
to the default settings.
Error resetting data buffer parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current data buffer
parameters for the appliance
cannot be updated to the new
parameters.
Error in updating data buffer
parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current data buffer
parameters for the appliance
cannot be displayed.
Error while retrieving data buffer
parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current storage lifecycle
parameters for the appliance
cannot be displayed.
Error while retrieving storage lifecycle
parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current storage lifecycle
parameters for the appliance
cannot be updated to the new
parameters.
Error in updating storage lifecycle
parameters.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The current BMR status for the
appliance cannot be displayed.
Error while retrieving BMR status.
Collect the web GUI and Perl logs all using
the DataCollect command and then
contact Symantec Technical Support.
The BMR settings for the
appliance cannot be enabled.
Error in updating BMR settings.
Error updating BMR status on this
appliance.
176NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Web Console