Symantec NetBackup 5220 - Page 177

Table 12-6
Manage > Host (continued)
Recommended actionExplanationError messages
Select the Enable BMR on this Appliance
option.
The BMR settings for the
appliance cannot be enabled.
The BMR option was not selected.
Table 12-7 lists all the error messages, displayed on the Manage > Appliance
Restore tab.
Table 12-7
Manage > Appliance Restore
Recommended actionExplanationError messages
Restart the appliance and then retry
factory reset.
System resources could be busy.Failed to reset all or some of the
appliance(s).
Look at the logs and contact Symantec
Technical Support for further
assistance.
Mount points could be busy.Failed to reset the storage. Check the
logs for additional information.
Roll back the appliance to a
post-upgrade checkpoint.
This error occurs when trying to reset
the appliance after it has been
upgraded.
Factory reset is not supported because
no factory checkpoints exist. Please
see the Symantec NetBackup
Appliance Administrator's Guide for
more information on how to reset this
appliance. Click ? for more
information.
Look for additional information, listed
above the error message. Retry the
operation. Cleanup is done in case of
such failures, which can free up disk
space.
This error can occur due to insufficient
disk space to store the checkpoint.
Appliance checkpoint creation failed.
Click Finish to go back to the
Appliance Restore page.
Look for additional information, listed
above the error message. Try to
correct the error and retry the
operation.
Secured network communication has
issues.
Checkpoint validation was
unsuccessful. The rollback operation
cannot be started. Click ? for more
information.
Contact Symantec Technical Support
for further assistance.
Appliance configuration (NetBackup
Appliance Directory) rollback failed.
Rollback of the appliance configuration
was not successful. Click ? for more
information.
Table 12-8 lists all the error messages, displayed on the Manage > License tab.
177NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Web Console