MC50 Integrator Guide10-4
Table 10-1. Rapid Deployment Window
Text Box/Button Description
Please scan all of the bar codes... This text box displays the status of a scanned bar code.
Waiting - indicates the mobile computer is ready to scan a bar code.
OK - indicates the mobile computer successfully scanned a bar code. (The Indicator LED bar on the mobile computer
turns green and a beep sounds).
If there are no bar codes left to scan, the Rapid Deployment Configuring window displays. See Figure 10-3.
Bar codes left to scan... This text box displays a list of any remaining bar codes to scan (1-D bar codes only). When all required bar codes are
scanned successfully, the Rapid Deployment Configuring window displays. See Figure 10-3.
About Tap About to display the Rapid Deployment Client Info window.
Reset Tap Reset to remove any previously scanned data.
Exit Tap Exit to close the application. A confirmation window displays:
Tap Yes to exit or No to return to the Rapid Deployment window.
Note: If the application is exited prior to scanning all required bar codes, any scanned data collected up to that point
is lost.
To Next Page
Loading...
