Issue 2: Sep 99 TMSL 097-44018-26
Page 151
COMMAND CODE: REPT ALM
PURPOSE
REPORT ALARM
This message reports the occurrence of alarms, including the access identifier, the severity of the alarm,
the type of condition, whether it affects service, when it occurred, and a short description of the alarm.
MESSAGE FORMAT
<sid> <date> <time>
<almcde> <atag> REPT ALM {EQPT|PORT}
"<aid>:<ntfcncde>,<condtype>,<srveff>,<ocrdat>,<ocrtm>:
/* <conddescr> */" ...
;
Note: All the parameters between the quotation marks will appear on a single line (the parameters are
shown on two lines here due to space restrictions). Refer to Table A and Table F for parameter values.
EXAMPLE
SANJOSE-114 1997-12-08 15:41:32
* 14 REPT ALM EQPT
"CLK-1:MN,HOLDOVER,NSA,1998-03-07,01:32:47:
/* CLOCK IN HOLDOVER */"
;
This example, tagged as automatic message 14, shows that clock 1 has a minor alarm, the clock is
in holdover, service is not affected, and that the problem occurred at 1:32:47 AM on Mar 7, 1998.
To Next Page
Loading...
Need help?
General
