118 XLi Time & Frequency System
XLi-man, Issue 8, 6/17/2008, Rev. H
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
Reboot Warning: Saving changes to any F100 parameter using the keypad/display will reboot the XLi.
Some of the F100 command line commands also reboot the XLi. These are identified in the following
documentation.
Group 1
You can use both the keypad/display and the command line interface to access the following
parameters:
• Ethernet address: XLi contains a unique Ethernet or Media Access Control (MAC) address
comprised of a unique number assigned to the manufacturer, and a unique number assigned to
the unit. This is factory set and cannot be changed.
• IP Address: Sets a static Internet Protocol (IP) address for the unit.
• Subnet Mask: Sets a valid subnet-mask used in IP addressing. Subnetting allows for the more
efficient allocation of network addresses and management of network traffic.
• Default Gateway: The address of the router that handles packets addressed to IP devices
outside the local-area network.
• 10 100 BASE-T: View network port setting: 10 or Auto (100 Base-T if available).
• Remote Lockout: Enables or disables TELNET access through the XLi’s standard network port.
Enabling Remote Lockout limits users to the front-panel keypad, Serial I/O port, or the web
interface (HTTP).
• Flash CRC: Status - Passed or failed.
• RAM: Status - Passed or failed.
• Serial: Status - Passed or failed.
• Version Test: Status - Passed or failed
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
