78 XLi Time & Frequency System
XLi-man, Issue 8, 6/17/2008, Rev. H
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
1
The XLi responds using the following format:
F51<S>B<N><SEP><SIGN><DELAY>ns<CR><LF>
where:
For example, to see the antenna cable delay for the GPS card in option bay 4, enter:
F51 B4<CR>
XLi responds:
F51 B4 +000060ns<CR><LF>
To set the antenna cable delay for an option card, use the following format:
F51<S>B<N><S><DELAY>NS<CR>
For example, to set the antenna cable delay for the GPS card in option bay 4 to 100 nS, enter:
F51 B4 100NS<CR>
XLi responds:
OK<CR><LF>
F52 – Distribution Cable Delay
Use function F52 to display or set the distribution cable delay for the time code and 1 PPS outputs. F52
compensates for the signal’s travel time from the XLi to its point of use. The distribution cable delay
applies uniformly to all output ports. The as-shipped factory setting is +0 ns. The range of possible
values is +999,999 ns to –999,999 ns. Positive values advance the timing signals, while negative values
retard them.
F = ASCII character F (f or F for input string).
51 = the function number.
<S> = ASCII space character one or more.
B = ASCII letter to denote Option Bay number follows
<N> = Option Bay Number of the GPS option card, 1 through 10.
<CR> = carriage return character.
<SEP> = one or more space characters.
<SIGN> = either + or blank
<DELAY> = 1 to 6 digit delay from 0 nS to 999999 nS.
ns = nanoseconds (ns or NS for input string).
<LF> = line feed character.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
