XLi Time & Frequency System 117
XLi-man, Issue 8, 6/17/2008, Rev. H
2
5
1
SSSSSSSSSSSS SSSSSSSSSS SSSSSSS S SSS S SSSSS S
To change the Code Output selection enter:
F90 IRIG-B DC<CR>
XLi responds:
OK<CR><LF>
Sample request for Time Code Out with IEEE 1344 extensions: F90<CR>
Response: F90 IRIG-120 1344
To enter the Code Output selection, send the following character string to the Serial/
Network port:
Sample entry: F90<SP>IRIG-B DC<CR>
Response: OK<CR><LF>
To enter the Code Output selection for Time Code with IEEE 1344 extensions, send the
following character string to the Serial/Network port:
F90<SP><CODE OUTPUT><CR>
where:
F = ASCII character F.
90 = function number.
<SP> = space
<CODE OUTPUT> = IRIG-B120 1344 or IRIG-B000 1344
<CR> = carriage return character.
<LF> = line feed character.
Sample entry: F90<SP>IRIG-B120 1344<CR>
Response: OK<CR><LF>
The Serial/Network port will respond with the message “ERROR 01 VALUE OUT OF RANGE” if
the input string was in the correct format but contained a value, probably numeric,
that was out of the range of acceptable values.
The Serial/Network port will respond with the message “ERROR 02 SYNTAX” if it receives
a string in an incorrect format.
The Serial/Network port will respond with the message “ERROR 03 BAD/MISSING FIELD” if
the input string lacks a required field.
IRIG-B120 1344
F100 – Network Port Configuration & XLi Firmware
F100 provides two groups of commands:
• Group 1, available through the keypad/display and the command line, provides access to
network port settings and hardware/Firmware status information.
• Group 2, available through the command line only, provides commands for changing system
firmware, changing NTP & SNMP parameters, changing the user name/password, resetting the
unit, and pinging other network devices.
Warning: The F100 commands have the capacity to remove the XLi from the network and disable the
XLi’s system firmware. Use judiciously.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
