Tascam DR-05 - Page 44

44 TASCAM DR-05
5 Use the + or – button to select TYPE , and
press the ¯ or Á button.
The procedure to select the creation of a
stereo or mono file is as follows.
Use the + or – button to select
STEREO
(default) or
MONO .
If
MONO is selected, a mono file is created, and
the same signals are sent to both L and R level
meters and output channels.
If sound is recorded in
MONO in WAV format,
the file size will be half that recorded in
STEREO , allowing long time recording.
6 Press the  button to show settings.
7 Use the + or – button to select
SAMPLE , and
press the ¯ or Á button.
Set the sampling frequency with the + or −
button to one of the following options.
44.1k (default), 48k , 96k
NOTE
96k cannot be selected if FORMAT is set to MP3.
8 Press the  button to show settings.
9 Use the + or – button to select
SIZE , and
press the ¯ or Á button.
4–Recording