Teac TD-9000T - Memory and Counter Settings; Internal Memory; Ok;Ng Counters

66
5. System settings
5-2. Memory and counter settings
To open the SYSTEM screen, touch the buttons in the following
order on the Home Screen.
⚙
e
CALIB. & SYSTEM
Use this to make unit settings and calibrate sensors.
SYSTEM
For information about system settings, see “5-3. Various
settings” on page67.
SENSOR
For information about sensor settings, see “4-2. SENSOR
settings” on page29.
5-2-1. INTERNAL MEMORY
Use this to set measurement data saving
ATTENTION
Data saved in the built-in memory is shown in a list of mea-
surement results. Waveforms can also be checked.
To check all data, set “SAVING” to “AUTO SAVE” and, as necessary,
set “OVERWRITING“ to “ALLOW.
SAVING
NO: do not save
AUTO SAVE: save everything
SAVE ON ERROR: save all not judged OK
OVERWRITING
ALLOW: overwrite the oldest data when the internal
memory becomes full
FORBID: do not overwrite any data
DELETE ALL
Touch EXECUTE to delete all data
5-2-2. OK/NG COUNTERS
Use this to reset counters.
Select the counter to reset and touch the OK button to reset it.