17
1. Names and functions of parts
The previous waveforms are shown using the interval data.
If a hold position is not at an interval data point, the hold
position data will be shown in place of the sample data imme-
diately preceding it.
Hold position
Nearest previous sample data
1-4-3. SENSOR MEMORY/WORK NUMBER
setting
Touch the Setting button (⚙) to change the sensor memory
and work number without opening the settings screen.
ATTENTION
If work switching is set to external input, work numbers cannot
be changed.
1-4-4. SD button
Touch the SD button to open the following screen.
SCREEN SHOT
This saves the Home Screen display on the SD card in bit-
map format.
The file will be saved with a name that starts with
“td9kt_screen_”.
RESULT (CSV)
The data shown when stopped will be saved to the SD
card.
NOTE
If data cannot be saved to the SD card, the button will appear
as follows, showing its status.
Button Status
The SD button appears red to show that some
error has occurred and writing could not occur
normally. If it always appears this way, for example,
format the SD card or replace it with another one.
The SD card is write-protected. Data cannot be
saved.
To Next Page
Loading...
