TEC MA-600 Series - Page 121

6. TERMINAL FILE PROGRAMMING EO3-11106
6.19 Department Table Programming
6-101
(continued from the previous page)
Operation LCD Display Remarks
Depress the [3] or [Enter] key.
“3 DP/PLU” is selected.
Depress the [1] or [Enter] key.
“1 DP” is selected.
Depress the [1] or [Enter] key.
“1 DP SETTINGS” is selected.
Depress the [Enter] key to select
Department 01.
*1: see NOTE below
The [?] key depression results in that the
following guidance message appears on the
LCD display.
Input 01 (or 1), then depress the
[Enter] key.
(Department Group No. 01 is set.)
The [?] key depression results in that the
following guidance message appears on the
LCD display.
Depress the [Enter] key.
(The open-price is set.)
The [?] key depression results in that the
following guidance message appears on the
LCD display.
The [Enter] key depression allows the
ECR to enter Department Status
setting menu.
The [?] key depression results in that the
following guidance message appears on the
LCD display.
(continued on the next page)