6. TERMINAL FILE PROGRAMMING
EO3-11106
6.7 Footer Message Programming
6-53
3) Example:
To program the following Footer Message.
Operation LCD Display Remarks
When the ECR is being outside a sale
and in SET mode, depress the [1] or
[Enter] key.
Depress the [↓] key.
The cursor is moved on to “2 FOOTER
MESSAGE”.
Depress the [2] or [Enter] key.
The message already programmed is
displayed.
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The [Enter] key depression allows the
ECR to enter the 1st line message
input mode. (The [C] key depression
clears the message already
programmed.) The 1st line message is
input.
(To program a message in a desired
line, move the cursor there with the [↓]
key then depress the [Enter] key.)
Numbers of programmed characters and of
programmable characters are displayed on
the 7-segment numeric display.
Example of key operation)
[→] [→] [→] [→] [→] [→] [T] [A/a] [h] [a] [n]
[k] [→] [A/a] [Y] [A/a] [o] [u] [Enter]
The [Enter] key depression results in
that the input message is entered and
displayed.
When the [Enter] key is depressed, the
message programmed in the 1st line is
printed.
(continued on the next page)
T h a n k y o u
C a l l a g a i n
Line No. 1
Line No. 2
Number of programmed characters
Number of programmable characters
To Next Page
Loading...
