44 1670 001-GB-I
HDA eco
31
5.2.1 Driver identification (optional)
The driver is identified by the associated ID (code or transponder + optional PIN). The
IDs are specified in the menu item ‘IDs’ (see section 5.3.3)
Display (e.g.):
A code with a maximum of 5 digits must be entered. A ‘*’ character appears on the
display for each digit entered. Entering leading zeros is not necessary.
A transponder tag can be used as ID instead of the code. Mixed operation (operator
code and transponder tag) is possible; each ID may be assigned either a code or a
transponder tag.
The transponder tag needs to have a distance of 1 – 2” to the reader. Acceptance is
indicated by a short beep tone.
It is possible to additionally issue a PIN with a maximum of 5 digits for each ID (code
or transponder), (see section 5.3.3.1.1).
If an incorrect code or an incorrect PIN is entered, or if a transponder tag is used that
has not been released, input is disabled for a period of time that is extended with
each subsequent incorrect entry.
Display (e.g.):
The current time is displayed in the lower line.
After dispensing, the dispensed amount from the last fuelling is displayed in the lower
line for 15 minutes after dispensing ends.
Entry of the master code or the use of the master transponder switches to the man-
agement operating mode.
Master code factory setting: 99999. It is absolutely essential to change this code
(see section 5.3.3.2)
5.2.1.1 Vehicle identification (optional)
The vehicle is identified by the associated ID (code or transponder + optional PIN) in
the same way as the identification of the driver.
Display (e.g.):
Driver:***
Pin:***
Vehicle:***
To Next Page