44 1670 001-GB-I
HDA eco
53
5.3.4.3.5 Initialisation / Restoring Factory Settings
Display (e.g.):
The device can be initialised here. Some of the factory settings are restored. Dispens-
ing data records and non-resettable totals (Total 1) are not deleted. The following val-
ues are manipulated:
The driver and vehicle totals as well as the resettable counter ‘Total 2’ are cleared
The non-resettable counter Total 1 is not deleted
The dispensing data records are marked as transmitted
All ID codes are deleted and the parameters re-initialised
The ‘Master code’ is set to “99999“ without Master Pin
The ‘Dispensing limit’ is set to 99999 L
The ‘Maximum ref. time’ is set to 30 minutes.
The ‘Ref. Timeout’ is set to 2 minutes
The ‘Contrast’ of the LCD is set to 44
The ‘Communication code’ is deleted.
The ‘Lock automat’ is released
The settings of a LAN, WiFi, and/or CMR interface will be deleted
5.3.4.3.6 Info Configuration
This display is intended for service purposes. It provides information about the con-
figuration of the automatic dispenser.
Display (e.g.):
5.3.4.3.7 Activation
This display is intended for service purposes. It can be used to change the configura-
tion of the automatic dispenser
Display (e.g.):
NOTE! Entering the incorrect information may result in existing options (e.g. fill
level probe connection) no longer being available!
5.3.4.3.8 Communication PIN
Display (e.g.):
Here an optional communication PIN for the transmission of data to the HD Manager
PC program can be viewed (but not changed). The communication PIN can only be set
or deleted using the HD Manager program.
Initialisation?
Info config.
Activation
Comm. PIN
To Next Page
Loading...