44 1670 001-GB-I
HDA eco
41
5.3.2.3 USB Report – Totals
A report of the counter readings is saved as text file on a USB flash drive
(‘DTOTDATA.TXT’ for drivers, ‘VTOTDATA.TXT’ for vehicles). The file can be opened on
a PC using a text editor and printed. Therefore a recordable USB flash drive has to be
inserted to the USB port of the automatic dispenser.
Display (e.g.):
File (e.g.):
5.3.3 Ident Codes menu
In this menu the IDs can be edited and ID reports can be created.
The medium for the identification of the driver or vehicle before the start of refuel-
ling is called an ID. Various system parameters can be specified for each ID. The mas-
ter ID is a special ID. It is required in order to access the management mode.
The ID (driver / vehicle / master) to be processed must be selected first.
Display (e.g.):
The respective ID can subsequently be accessed via the sub-menu.
Display (e.g.):
The ID to be edited can be selected using the ‘▲’ and ‘▼’ keys; ‘-‘ means that the re-
spective ID has not been set up. In case a transponder has been set as access authori-
sation for an ID, the entry ‘TRANS’ appears instead of the code.
After selecting an ID switching between its different parameters takes place using the
‘◄’ or ‘►’ buttons. Press the ‘
ENTER
’ button to change the parameter and ‘
EXIT
’ to
complete the entry.
Saving report
100 / 100
HDM eco 1820025
USB Report - total data
................................
Date 24.03.12 Time 08:20
Vehicle totals
Total 1: 1430 L
Total 2: 611 L
Vehicle 1: 275 L
Vehicle 2: 569 L
Vehicle 100: 26 L
Vehicle ---: 5 L
................................
Menu Ident
♦ Driver 3
To Next Page
Loading...