44 1670 001-GB-I
HDA eco
37
5.3.1.1 Show Refuellings
Display (e.g.):
All of the refuellings stored in the memory can be viewed, beginning with the last dis-
pensing event. The refuelling to be displayed can be selected using the ‘▲’ and ‘▼’ but-
tons. The ’◄’ and ‘►’ buttons can be used to select the individual dispensing data (date,
quantity, driver, vehicle, mileage, order no). For cancelling use ‘
EXIT
’.
The status of the dispensing event is shown by means of letters / special characters
after the time. Meanings:
‘
T
’ : Dispensing interrupted due to timeout
‘
X
’ : Dispensing data record was transmitted / saved to the
USB flash drive
When pressing the ‘
ENTER
’ button an input mask appears. There the
displayed dis-
pensing data set and all newer ones
can be marked as not transmitted. So these data
can be retrieved from the PC or printed out again following e.g. loss of data or trans-
mission errors.
Display (e.g.):
Confirm with ‘
ENTER
’, abort with ‘
EXIT
’.
5.3.1.2 Print Refuellings (Option ‚Printer‘)
Display (e.g):
All the data stored in the memory can be printed.
The delivery (of fuel) to be printed is selected in the same way as described in the
menu point, i.e. via buttons‚▲‘ and ‚▼‘. Using the ◄‘ and ‚►‘ buttons it is possible to
display details relating to the delivery (data, quantity, driver, vehicle, kilometrage, or-
der number).
The displayed data set is printed by actuating the 'ENTER' button, abort using 'EXIT'.
Refuelling data
Refuell.: 53 ♦
24.03.12 14:44
Refuell. 53 ♦
To Next Page
Loading...