32 44 1670 001-GB-I
HDA eco
5.2.1.2 Tank content display (optional)
It is possible to switch to the tank content display from the input screens for the
driver or vehicle identification by pressing the ‘▼’ button. The contents in percentage,
the measured level and the contents in litres are displayed. (Only if the level probe is
installed and set up.)
Display (e.g.):
The display disappears automatically a few seconds after the button is released.
5.2.1.3 Software version display
It is possible to switch to the display of serial no., hardware revision and the software
version from the input screens for the driver or vehicle identification by pressing the
‘►’ button.
Display (e.g.):
This information is requested by our customer service staff in the event servicing is
required. The display disappears automatically a few seconds after the button is re-
leased.
5.2.2 Dispensing without entering a code (optional)
If Code query: ‘none’ has been selected in the dispensing options in section 5.3.4.1.1
I, dispensing is possible without entering a code by pressing the ‘
ENTER
’ key. Never-
theless, if a vehicle code is available it can be entered; the dispensed fuel will then be
assigned to it.
Display (e.g.):
The code query serves only to switch to the management operating mode with the
master code (see section 5.3).
Notice: If “
ID query: none”
has been selected and the
Order
and
Mileage
queries have
been deactivated too, dispensing begins as soon as
the “ENTER” key is pressed or
the
nozzle is drawn
when a nozzle switch is installed.
Tank 20%
S/N 1802456 HW:E
Code:***
To Next Page
Loading...