54 44 1670 001-GB-I
HDA eco
5.3.4.3.9 USB PIN
Display (e.g.):
Here it can be specified if the retrieval of the refuelling data via USB flash drive in
dispensing mode is to be protected against unauthorised access by the input of mas-
ter code or by the use of the master transponder.
You can choose between ‘yes’ and ‘no’.
5.3.4.3.10 Menu Interface for LAN socket modem option
Display (e.g.):
This menu is only available if a LAN socket modem has been selected as the inter-
face. This is where users can enter the necessary parameters for operating the LAN
socket modem. The type and number of menu items vary depending on the nature of
the connection type. A corresponding note points this out (where applicable) in the
description of the individual menu items.
We recommend not configuring the settings manually, but instead generating them on
the website www.mytecalemit.com and importing them into the fuel terminal using a
USB flash drive.
For operation with mytecalemit Cloud, the LAN must fulfill the following prerequi-
sites:
Connecting the HDA eco to the internet must be possible without having to log in
to a proxy server, as the HDA eco does
not
support a login.
Port 53 for DNS queries must be enabled for the TCP/IP protocol.
The HDA eco does not perform any DNS queries via the UDP protocol.
This menu is only available if a LAN socket modem is present (option). This is where it
is possible to enter the necessary parameters for operating the LAN socket modem. If
necessary, a network administrator should be consulted for the correct settings and
adjustment to the existing network. Select the menu points using the ‘▲ and ‚▼‘ but-
tons and confirm with 'ENTER', abort with 'EXIT'.
5.3.4.3.10.1 Ident. No. (LAN)
Display (e.g.):
This is where you can see the identification number (device serial no.) for clear identi-
fication of the HDA eco in the network (unchangeable). Leave the menu point with
'EXIT'.
USB Pin
Menu Interface
Ident. No.:
To Next Page