TECALEMIT HDA eco - Receipt (Option Printer); Menu Dispensing Point; Product Number; Pulses; Litres

44 1670 001-GB-I
HDA eco
49
was completed). A time between 1 and 98 minutes can be entered. Default value: 1
minute.
b. Unit set to "Seconds":
The time-out time only commences when a small amount of medium has been dis-
pensed.
If this does not take place within 60 seconds (regardless of the time set), the device
will terminate the dispensation.
5.3.4.1.9 Receipt (Option ‚Printer‘)
Display (e.g.):
If this menu point is
'yes'
, an receipt is printed out on a connected printer. This menu
item is only available if the HDA eco has the option socket modem RS-232 or RS-422 .
5.3.4.2 Menu Dispensing Point
Display (e.g.):
After selection of the menu items, the corresponding dispensing point parameters can
be adjusted in the respective sub-menus.
5.3.4.2.1 Product number
Display (e.g.):
This menu item allows an identification number to be assigned to the product when
there are multiple HDA eco units which dispense varying products. The values that
can be configured range from 1 (factory default) to 90.
5.3.4.2.2 Pulses / Litres
The range of the pulse value: 1.00 up to 1000.00
Display (e.g.):
The pulse value of the used pulse generator can be set in this menu. The number of
volume pulses per litres must be entered. A value between 1.00 and 1000.00 can be
entered.
The default pulse value is 53,95, equivalent to the pulse value of the FMOG100 flow
meter. (This means 53,95 pulses per litre.)
Product number
1
Menu Dsp. Point
▼
Product number
Pulses / Litre
53,95
Receipt
◄►yes