42 44 1670 001-GB-I
HDA eco
5.3.3.1 Code
A driver code with one to five digits can be entered. An existing code can be deleted
by confirming deletion.
Instead of the five-digit code, a transponder tag can be assigned to an ID. The tran-
sponder tag needs to be held at a distance of 2 – 5 cm to the reader. A beep tone in-
dicates that the transponder tag has been read.
5.3.3.1.1 PIN
A 1 to 5-digit PIN can be entered in addition to the code or the transponder tag. In
case a PIN was assigned it has to be entered after the code. Only some (or none) of
the IDs can be assigned with a PIN.
Display (e.g.):
5.3.3.1.2 Refuelling Limit
Here a refuelling limit per refuelling can be entered for the vehicle, maximum 9999
litres.
Display (e.g.):
Attention:
If the general dispensing limit for the dispenser is lower, then this applies
.
5.3.3.1.3 Maximum Refuelling Time
Here a refuelling time limit per refuelling can be entered for the vehicle, maximum 99
minutes. The default value is 30 minutes.
Display (e.g.):
Attention
:
If the general dispensing time limit for the dispenser is lower, then this applies.
5.3.3.1.4 Odometer or Operating hours Request
Depending on the vehicle type, prior to refuelling the odometer reading or operation
hours of the vehicle can be entered to calculate the fuel consumption using additional
software, e.g. HD Manager. Here it is specified whether the odometer reading or oper-
ating hours (hrs) are input. For odometer reading you can choose between Kilometer
(km) or Miles (mls).
Display (e.g.):
♦ Vehicle 1
♦ Vehicle 1
♦ Vehicle 1
♦ Vehicle 1
To Next Page