14. Remove the gradient motor.
15. Remove the elevation system.
16. Put the equipment in vertical position.
For details, refer to the disassembly procedure described in the chapter:
$7.23 DISASSEMBLING THE RUN SURFACE
Details about the disassembling of the elevation system:
Remove the two screws indicated, (TOOL: 6 mm hexagon key wrench).
ATTENTION: During reassembly the pin of the elevation system, Apply Loctite 243 on the
thread of the pin.
TECHNOGYM RUN Technical Service Guide
Rev. 1.0
- 62 - TSG-00284-EN- Uncontrolled copy if printed
To Next Page
Loading...
