Technogym Synchro Excite 700 - Hand Sensor Board Disassembly

SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
Pagina 7.24
7.9. HAND SENSOR BOARD DISASSEMBLY
Only for version: 700, 700SP and 700WTV.
Figure 7.9-1
Carry out the operations described in
paragraph: 7.7.2. “Brake box cover guard” and
7.7.3. “Front guards”.
1. Back off the 4 screws with a small Phillips
screwdriver, that fix the support plate at the
frame.
2. Unplug connectors shown in the figure at the
side.
3. Release the clipsand to remove the board and
replace if necessary.
To reassemble the hand sensor board, carry out
the above steps in reverse order.