SYNCHRO EXCITE Class & Trend: Service & maintenance manual - rev. 2.0
Page 9.9
9.2.4. PAUSE TIME
It is possible to set a maximum pause time for each exercise in seconds, with values ranging from
10 to 999. To change the setting, when the display shows the current maximum time:
PAUSE TIME : xxx
Press the ENTER key to modify the value: when the current parameter value starts to blink, press
the CLEAR key to erase the current value and then use the number keys to enter the desired new
value.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 60.
9.2.5. COOLDOWN TIME
It is possible to set the cooldown time for each exercise, ranging from 5 to 180 seconds. To change
the setting, when the display shows the currently selected maximum time:
COOLDOWN TIME xxx
Press the ENTER key to change the value: The current parameter value starts to blink on the
display; use the ↑ and ↓ keys to increase or decrease the value, or use the +/- GOAL keys to scroll
through and modify the individual digits.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
The default value of this parameter is 60.
If you are exercising with a TGS key, the cooldown will be stopped if you extract the key.
9.2.6. ENABLE TGS
It is possible to enable or disable the use of the TGS reader. To change the selection, when the
display shows the current setting:
TGS : xxx
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
TGS
ENABLED <default>
DISABLED
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter.
To Next Page
Loading...
